How to overhaul the foam forming machine_how to use the foam forming machine

I hope that through the introduction of this article, you can have a certain understanding and understanding of how to repair the foam molding machine and other aspects. Let's follow the experts of Huasu to take a look at the relevant content. Introduction The foam molding machine is for foam, sponge, etc. A device for processing materials required by the chemical industry. At present, the laser machine is mainly used for cutting. Due to the advantages of laser beam fine cutting, such as not easy to deform, smooth cutting, and no edge, it is currently used in various fields. Of course, it is inevitable that there will be failures during the use of the foam cutting machine and need to be overhauled. Now let's talk about the following precautions during overhaul.　　Only personnel who know how to use and operate are allowed to repair machinery or replace components! In order to prevent accidents or damage to the machine, the following principles must be observed during maintenance: 　　1. When a fault occurs, disconnect the power supply to stop the machine; 　　2. When the machine cannot be used normally, check the relevant manuals and use The manual determines the correct measures to be taken; the power supply must be turned off before overhauling or replacing components. 3. The parts (components) removed during the overhaul should be replaced with the same new parts (components) in place, and the instruments used in the overhaul must be calibrated; 　　 4. It is strictly forbidden to leave flammable or metal objects in the electrical cabinet or Inside the junction box; 　　 5. Regularly check whether the cables and wires have damaged foam, and how to check and repair the foam molding machine to prevent leakage or electric shock. You may like this article better: the working principle of the molding machine is similar to that of the syringe used for injection. It uses the thrust of the screw (or plunger) to inject the plasticized plastic in the molten state (that is, the viscous state). The process of obtaining the product after curing and shaping in the closed cavity. How to use the forming machine: 　　 1. Choose a flat table and stabilize the machine. The legs of the forming machine can be pulled apart to make the machine panel easy to observe.　　 2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Pay attention to the positioning gap.　 3. Insert one end of the plug of the power cord into the socket on the rear panel of the chassis, and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply.　 4. Turn on the 'main power switch' on the back panel of the molding machine, press the 'power switch' button on the panel, and wait for the 'ready' green indicator light to turn on, the machine can work. The content described in 'How to check and repair the foam forming machine' is carefully prepared by our editor. Do you remember what was said in the previous article? These may all be incomplete, and we will explain them one by one in future articles.
The manufacture marketing game of automation equipment manufacturer is changing with each innovation, and businesses of all products need to be ready to pounce.
Super quality are in offer at Veinas Machinery, welcome to visit us.
It is one of the best products available in the market today. automation equipment manufacturer is famous product in many oversees market.