How to adjust the pressure of the cutting machine

The vertical cutting machine is a small die-cutting machine that is manually operated and is suitable for cutting products with small specifications. Because the size of the cut die is different and the thickness of the material is not the same, the pressure required is not complete. The following describes how the rocker can adjust the pressure. There are two main ways:

1、Under normal circumstances, fine-tune the machine pressure by the knob on the swing arm head

Adjustment knob: When the knob is adjusted to the minimum, the pressure is minimum; when the knob is adjusted to the maximum, the pressure is maximum

2、Adjust the hydraulic valve inside the cutting machine

Step 1、 Adjust the screw pointed and adjust the pressure to the left and right.

Step 2、After adjusting to the applicable pressure, tighten the screw pointed

Setting of cutter height of cutting machine

1, remove the debris on the working surface of the board, will be placed in the center of the plastic mold;

2, the machine starts, will set the handwheel release, the pressure system to zero;

3, set the switch to the right to the "knife mold set" direction, cutting plate 13 that began to slow down to close the knife die will automatically stop;

4. Set the handwheel to the bottom and tighten it. Set the switch system (left) to the "cut" position before starting 04;

5, and then press the brake switch, the cutting plate on the immediate recovery to the highest position, at this time the knife mold set is completed.

Adjustment of precision eva foam cutting machine

1, setting of the knife mold work is completed, will be laid on the material on the plate, then put in the knife mold materials, and then promote the feed plate cutting area; 

2, respectively, with both hands pressed 12 cutting switch, at this time decreased pressure on the cutting platen die cutter, cutter to cut off the material automatically after back to the position before starting to stop;

3, in the blanking material, such as material found not completely cutting when the cutting depth of 03 to adjust the controller, the "pressure system" to counter clockwise direction of rotation; such as knife rubber molded into too deep, will be "pressure system" to the counter clockwise rotation, adjustment of the longer the cutting depth is deeper, try to to adjust the cutter slightly pressed into the sheet so far;

4, the material will be pulled out of the cutting area, take out the material, in order to complete a blanking process.