How to use the foam forming machine_how to maintain the foam forming machine

In the introduction to the use of the foam molding machine, we have learned some unknown problems or knowledge, but we are still relatively unfamiliar with the industry in which 'Hebei Changxing Foam Machinery Co., Ltd.' is located. We will come today. Understand: The working principle of the molding machine is similar to the syringe used for injection. It uses the thrust of the screw (or plunger) to inject the plasticized plastic in the molten state (that is, the viscous flow state) into the closed mold cavity Inside, the process of obtaining the product after curing and shaping. How to use the forming machine: 　　 1. Choose a flat table and stabilize the machine. The legs of the forming machine can be pulled apart to make the machine panel easy to observe.　　 2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Pay attention to the positioning gap.　 3. Insert one end of the plug of the power cord into the socket on the rear panel of the chassis, and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply.　 4. Turn on the 'main power switch' on the back panel of the molding machine, press the 'power switch' button on the panel, and wait for the 'ready' green indicator light to turn on the foam, and the foam molding machine can be used. Related article recommendation: In fact, when we buy this type of equipment, we pay special attention to its quality. In fact, if we want to extend the service life of this type of equipment, as long as the daily maintenance work is done, it will naturally be guaranteed. Daily maintenance. In fact, the maintenance of the molding machine is divided into two parts. The daily maintenance work is relatively simple, but there may be some tasks that are done every day, so we try to implement the maintenance work on the head every time the equipment is used. . Before handing over the shift every day, we must still check the equipment, and some parts may also need to use lubricant. Regular maintenance work. Regular maintenance of the molding machine is also very important. After all, some internal parts are also prone to wear and tear. This type of equipment must be used every day. If the internal parts are really worn out, we must also replace them. , In order to avoid more serious failures of the equipment. The content described in 'Using Method of Foam Molding Machine' was prepared by our editor meticulously for everyone. Remember what was said in the previous article? These may all be incomplete, and we will explain them one by one in future articles.