[Article] Precautions for Shutdown of Real Gold Board Equipment Correctly Understand Foam Molding Machine

The development of many industries in life is inseparable from the eps building module equipment. Sometimes some inconspicuous factors may cause a big gap. For example, as mentioned before, today we will take a look at the 'real gold board'. Precautions for shutting down the equipment Correctly understand the foam molding machine. 1. The preparation and inspection work to be done before the operation of the real gold EPE foam machine: 1. Check whether the components and power supply of the real gold board equipment are normal, whether there are any loosening, leakage and other problems. 2. Open the tap water valve and check whether the tap water flows normally and the water flow meets the requirements. 3. Check whether the switch position of each steam valve of the real gold board equipment is accurate. 4. Check the steam pressure reducing valve, plug the safety plug tightly, and then tighten the outer cover. 5. Drain the water in the equipment from the drain. 6. Check whether each steam pressure control meter is normal. 2. When the real gold board equipment is shut down, the work that needs to be done: 1. Turn off the power supply, vacuum pump tap water and steam valve of the real gold EPE foam machine. 2. Establish real gold board equipment operation records and equipment account management, and continuously improve the data and operation of real gold board equipment. 3. Pay attention to the correct spot inspection of real gold board equipment, the precautions for shutting down the real gold EPE foam machine, and overhaul work according to the equipment life cycle. 4. Do a good job in the reserve and management of vulnerable parts of real gold board equipment. More people like: The working principle of the molding machine is similar to that of the syringe used for injection. It uses the thrust of the screw (or plunger) to inject the plasticized and molten state (ie, viscous flow state) plastic into the closed one. In the mold cavity, the process of obtaining the product after curing and shaping. How to use the forming machine: 　　 1. Choose a flat table and stabilize the machine. The legs of the forming machine can be pulled apart to make the machine panel easy to observe.　　 2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Pay attention to the positioning gap.　 3. Insert one end of the plug of the power cord into the socket on the rear panel of the chassis, and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply.　 4. Turn on the 'main power switch' on the back panel of the molding machine, press the 'power switch' button on the panel, and wait for the 'ready' green indicator light to turn on, the machine can work. The above is a brief introduction about the 'Precautions for Shutdown of Real Gold to Know the Foam Molding Machine correctly'. Our company also has many related products such as eps building module equipment, eps building module equipment, etc. If you are more interested, you can contact us Get more details. Keywords in this article: real gold equipment power supply inspection work
However, automation equipment manufacturer isn't the only producer in domestic, and many people feel that Zhuhai HuaSu Automation Machinery Equipment Co.,Ltd's service leaves much to be desired in terms of functionality and design.
For many years, Zhuhai HuaSu Automation Machinery Equipment Co.,Ltd has searched for and found a number of secrets to help you machine manufacturer. Go to Veinas Machinery to learn about some of those secrets.
The above are only part of the examples regarding automation equipment manufacturer, for more information, please click here Veinas Machinery.